InSinkErator Evolution Excel User Manual download pdf (Page 4)

Falling Hazard

WARNING

Removal of old disposer:

Disconnect drain trap from waste

discharge tube. Disconnect

dishwasher if connected to the

disposer.

Support disposer, insert end of

Jam-Buster

wrench (K) into

right side of mounting lug, and

turn. Disposer will fall free.

*WARNING: SHOCK HAZARD

With the electrical supply turned

off, flip disposer over and remove

electrical cover plate. Save cable

connector if applicable.

*WARNING: SHOCK HAZARD

With the electrical supply turned

off, disconnect the disposer wires

from the electrical supply.

If the new disposer mount-

ing is the same as the old one,

you can go to step 15. Note:

For sinks thicker than 3/8”, you

will need to replace existing 1

1/2” screws with 1 1/8” screws

(H). See step 14.

SHOCK HAZARD

Turn off electric power at

fuse box or circuit breaker.

W A R N I N G

Loosen the 3 screws on the

mounting assembly.

Using a screwdriver, remove the

snap ring.

Remove flange from sink. Remove old plumber’s putty from

sink with putty knife.

If you are replacing

an existing disposer,

continue to Step 2.

If there is no existing

disposer, disconnect

sink drain and skip to

Step 10.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

InSinkErator Evolution Excel User Manual Page 4

Comments to this Manuals