Insinkerator LC-50 User Manual

Part No. 13693 - January 2008LC-50 FOOD WASTE DISPOSERInstallation Manualwww.insinkerator.comPlease be certain that the person who installs or uses th

10DO'S AND DON'TS DO … • First turn on a moderate to strong flow of cold water and then turn on the disposer. Continue running cold wat

11Operating InstructionsPERSONAL INJURY • Read all instructions before using the appliance. • To reduce the risk of injury, close supervision is requi

12TroubleshootingTroubleshooting for problems other than what is listed below should be performed by a qualified service person. Troubleshooting perfor

13TroubleshootingTroubleshooting for problems other than what is listed below should be performed by a qualified service person. Troubleshooting perfor

2Table of ContentsIntroduction Clean the Drain Line ... 3 Required Tools/Materi

3IntroductionIn This PackageREQUIRED TOOLS/MATERIALSThe following items are needed to install the disposer:• Screwdriver• Pipe wrench• HammerThe fo

4Wall SwitchElectric SupplyPush ButtonSyphon BreakerSolenoid ValveWater Shutoff ValveCold Water SupplyElectrical Junction BoxAir HoseAir SwitchPower J

5Disconnect drain trap from waste discharge tube. Disconnect dishwasher or direct water connection if connected to the disposer.Support disposer, inse

6Loosen the 3 screws on the mounting assembly. Using a screwdriver, remove the snap ring.Removing Existing DisposerEvenly apply 1/2" thick rope o

7Installing the DisposerTighten screws evenly and firmly against backup flange. Use shorter 1-1/8" screws if sink is more than 3/8"thick.Turn

8Electrical ConnectionsPush wires into disposer (do not displace cardboard shield) and replace electrical cover plate.19Connect white to white and bla

9Final InstallationHang disposer by aligning 3 mounting tabs with slide-up ramps on mounting ring.21Turn mounting ring until all 3 mounting tabs lock