Insinkerator C1300 User Manual download pdf (Page 5)

Electric Shock Hazard: To prevent electrical shock, disconnect power before

servicing unit. Use only a properly grounded and polarized electric outlet.

Only use mild cleaners to clean

the dispenser’s faucet and

plastic components.

Cleaners with acids, alkaline,

and organic solvents will result

in deterioration of the plastic

components and void the warranty.

CLEANING THE FAUCET AND TANK

Factory temperature pre-set is

200˚F. To reset the thermostat

to 200°, turn the indicator two

notches to the right of vertical.

Adjust the thermostat

slowly, turning the dial

clockwise to increase

temperature or counter clockwise to

decrease temperature, then activate faucet

handle for 20 seconds to bring in fresh

water to be heated at the new setting. Allow

5-7 minutes for water to reach new tem-

perature.

Property Damage:

Regularly inspect the unit for any

signs of leakage. If there are signs

of water damage, turn off the water

supply and contact an authorized

InSinkErator Service agent.

A drain pan, plumbed to an

appropriate drain or outfitted with

a leak detector, should be used in

those applications where any

leakage could cause property damage.

NOTICE

Anytime the instant hot water dispenser is not used for

extended periods of time, unplug and drain unit. If it is

below freezing you will need to unplug the unit and drain it.

SEASONAL STORAGE/DRAINAGE

Disconnect power from unit (unplug unit).

Push hot water dispenser faucet lever

and allow water to flow until it is cool.

Shut the cold water supply off at the valve.

Disconnect tubes from the tank.

Unhook tank from wall.

Hold tank upside down and drain the

water into the sink.

Towel dry any water drippings from

tank area.

Reinstall tank to wall and reconnect tubes.

To put back into working order, turn on

cold water supply at valve. Depress the

hot water dispenser faucet lever and

hold until water flows from the spout.

Reconnect the electrical cord. (Refer to

Step 6B)

CARE AND USE

approx. 200°

Scalding Hazard: Do not allow

water to boil. May result in

severe burns.

ADJUSTING THE THERMOSTAT

IMPORTANT SAFETY INFORMATION

Fire Hazard: To minimize possibility of fire, DO NOT store flammable items such as rags,

paper or aerosol cans near the tank. DO NOT store or use petrol or other flammable vapours

and liquids in the vicinity of this or any other appliance.

Leak Hazard: Regularly inspect dispenser and plumbing fittings for leaks, which can

cause property damage and could result in personal injury

A steaming hot water tap, like any water heater, has a limited life and will eventually fail. To avoid possible property

damage and personal injury, this steaming hot water tap should be regularly examined for leakage and/or corrosion and

replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used

in those applications where any leakage could cause property damage.

n Use this water heater only for its intended use as described in this manual.

n This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction

concerning use of appliance by a person responsible for their safety. Children should be supervised to ensure that

they do not play with hot water tap. To reduce the risk of injury, close supervision is required when an

appliance is used near children.

n Do not operate this product if it has been or appears to be damaged in any manner or after the product

malfunctions, or is dropped. Return the complete product immediately to your retail dealer for inspection, and

if necessary, adjustment or repair.

Important: Always arrange the power cord so that it cannot come in contact with hot surfaces.

n Do not disconnect the product from the power supply by pulling on the cord.

n Do not use the product for other than its intended use as described in these instructions. The use of accessory

attachments other than those recommended by the manufacturer may cause safety hazards.

n The recommended connection may be made to an existing cold water line with a branch terminating with a shutoff

valve, a pressure relief and dual check non-return valve sited adjacent to the product.

Electric Shock Hazard: To reduce the risk of electric shock, do not immerse or expose

the product, ﬂexible cord or plug to rain, moisture or any liquid or when standing in

or on damp or wet surfaces. If any electrical product falls into water, UNPLUG it

immediately. DO NOT REACH INTO THE WATER. Important: Prior to reconnecting to the

power supply, the product should be inspected by a qualiﬁed technician.

To reduce the risk associated with the ingestion of contaminants: Do not use with water

that is microbiologically unsafe or of unknown quality without adequate disinfection before

or after the system. Systems certiﬁed for cyst reduction may be used on disinfected water

that may contain ﬁlterable cysts. EPA Establishment #070595-CT-001.

Personal Injury/Property Damage: To reduce the risk associated with hazardous volt-

age due to an installer drilling through existing electric wiring in the area of installation:

Do not install near electric wiring which may be in path of a drilling tool when selecting

the position to mount the system bracket.

Also avoid the risk of drilling into water pipes which may result in property damage.

This appliance must be earthed (grounded). This steaming hot water tap is equipped with a cord that has a grounding

conductor and earth ground pin. The plug must be connected to an appropriate outlet that is properly installed and earthed

(grounded) in accordance with all local codes and ordinances. Do not modify the plug provided with the appliance – if

it will not fit the outlet, have a proper outlet installed by a qualified electrician. Check with a qualified electrician or

tradesman if you are in doubt as to whether the steaming hot water tap is properly earthed (grounded).

Electric Shock Hazard: Using an ungrounded (no earth ground) or improperly

connected appliance can result in serious injury or death from electrical shock.

To reduce the risk associated with choking: Do not allow children under 3 years of age to

have access to small parts during the installation of this product.

Personal Injury/Property Damage: This tank is a non-pressurized tank. DO NOT modify

this system. DO NOT close vent tube or connect other types of taps or valves to the tank.

Use only the InSinkErator tap supplied. Use only parts provided. Contact an authorized

InSinkErator Service agent for repairs or replacement components.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Insinkerator C1300 User Manual Page 5

Comments to this Manuals