Insinkerator HC3300 User Manual download pdf (Page 4)

Property Damage: Do not pinch or break copper tubing.

Do not distort the last 25mm of tubing.

HC3300/H3300

■ Unpack hot water tap components.

■ The recommended installation for this

tap is the tap handle on the right.

The unique design allows the handle

to be fully functional when placed to

the right or left of the hot water tap.

Determine preferred handle placement

before installing.

A

INSTALLING THE TAP - HC3300/H3300

2

HC3300/H3300

■ Insert rubber O-ring into groove on

brass seat.

■ Place brass seat, O-ring side down,

over hole in sink or worktop.

HC3300/H3300

■ Holding brass seat in place, feed

tubes down through the hole in sink

or worktop until base touches

brass seat.

■ Rotate brass seat until the two retaining

studs fit into the holes on the tap base

and base sits firmly on brass seat.

HC3300/H3300

■ From under the sink, place the

semicircular mounting plate onto

the threaded stud.

■ Place hex nut onto the threaded stud.

Ensure tap handle is on preferred side

and that tap head is at desired angle.

■ Insert screwdriver into hole on side of

hex tool (creating a “T”), and use tool

to tighten nut and secure tap.

B

C

D

Wetting O-ring with water prior to

inserting into brass seat helps hold

ring in place during installation.

To ease feeding of tubes through hole, first

insert blue tube with quick-connect attachment

and then insert the remaining tubes.

Semi-circular mounting plate should

encircle all descending tubes and

extend beyond sink hole when tight.

4

Mount tank vertically in an area that allows clearance

on the underside of the tank for drainage, if

necessary. DO NOT over-tighten screws.

■ Pre-drill 3mm pilot holes at marks.

■ Turn screws into pre-drilled holes,

leaving 6.4mm exposed.

■ Hang the tank on the screws.

■ Tighten the screws with only 1/2

turn clockwise.

Screws provided are for use in wood studs or

cabinets only. Use wall anchors (not supplied)

for installation into plasterboard.

CONNECTING TAP TO TANK

MOUNTING THE TANK

■ Select a spot under the sink to mount

tank vertically within reach of both

plumbing and electrical connections.

The tank should be within 400mm or

less of tap water lines and within

760mm or less of a standard earth

(grounded) outlet.

■ While holding tank in place on the spot

selected for installation, use a pencil to

mark locations for 2 hanging screws.

Personal Injury/Property Damage: Tank must be

located within 400mm of tap and within 760mm or

less of a standard earth (grounded) outlet. DO NOT

extend plumbing or electrical lines.

■ Without depressing the grey button,

place the snap-connect fitting at the

end of the blue tube onto the left

plastic fitting on the tank, pushing until

it clicks into place. (1)

■ Slip the flexible white tube over

barbed middle fitting and slide down

approximately 12mm. (2)

■ Slip the small white tube over the

far right smooth fitting and slide down

approximately 12mm. (3)

■ Visually check for pinched or

crimped tubes.

Hose clamps are not needed for any of the connections.

Tank must be

mounted level

to ensure

proper operation.

Leave 12mm for

hanging tank.

Property Damage: Pinched or blocked water lines

may cause damage to the water tank. Check to

make sure tubes are connected properly and are

pushed in as mentioned.

3

4

B

A

A

(1)(2) (3)

1 2 3 4 5 6 7 8 9 ... 79 80

Comments to this Manuals

No comments